Holiday Ship Dates

Free shipping: Orders over $200

Free US shipping on orders over $200

$12.99 Shipping: Orders under $200

$12.99 Flat Rate Shipping on orders less than $200

How to use the LennyLight SSC

First, adjust your carrier's panel height and width.
Adjust the height by using the pull tabs on the panel.
Adjust the width by using the Velcro adjuster inside the waistband.

What panel adjustment should I use?
For width: Babies younger than 1yr old should be supported from knee to knee. Children 1yr or older should be supported at least mid-thigh to mid-thigh. Older babies can be supported knee-to-knee, but don't overextend. You want your child's legs to swing freely. Use the markings as a guide, but know that each child is unique. You may need to try different settings to find the width that works best for you.
For height: For babies who cannot yet support their head, make sure the panel height is no higher than the bottom of the ear and adequately supports baby's neck. For a child with adequate trunk support (usually around 6mon old), the top of the panel should be no lower than just below your child's armpits, and no higher than the bottom of the ear. Any lower and your child could toss themselves out by leaning backward! Any higher and you could interfere with your child's airway.
  
Convenient 2-way arm strap adjusters
Adjust the bottom of the shoulder straps to your desired tightness by either pulling up or pulling the other strap down.
 
Customize the Chest Clip
Slide the chest clip up or down the shoulder straps as it is comfortable for you. You can also loosen or tighten the chest clip as desired. If you're using the cross-strap option, you don't need to use the chest clip at all!
 
Cross them or ruck it
The arm straps can be unbuckled to cross the straps. This is a great comfort option for many caregivers. It can also make it easier to put the carrier on by yourself! Easily switch between ruck and cross-strap options for different outings or different caregivers. 

Once you're adjusted, put your baby in the carrier

Front Carry:

  1. Buckle the waistband with the velcro adjustment side facing you and the panel in front. Be sure to put the buckle through the elastic safety band before closing. This provides extra fall protection for your child.
  2. Place your child into the panel, facing you. Center them in the panel, then lift the panel up over your child's back. To get the best fit, try to reduce slack in the panel by lifting the straps high in the air and gently bouncing your child into the panel. You want them to sit out in the panel, not on the waistband itself.
  3. Method A - Put your arms through the ruck straps. Reach behind you to fasten the chest clip. The magnetic clip should fasten easily! Experiment with how loose you leave the straps, including the chest clip, before putting your child in the carrier, to see what's most comfortable for you. When buckled, use the webbing to tighten as is comfortable.
  4. Method B - Alternate H method, if you can't reach behind your back to clip the chest clip: Prior to putting your child in the carrier, unclip the arm straps so they hang loose, and buckle the chest clip. When your child is in the panel, lift the straps over your head. Your head will go through the top of the "H," above the chest buckle, which you've already clasped. Once the straps are behind you, buckle each arm strap on its respective side. Don't forget to put the buckle through the elastic safety band before buckling
  5. Method C - Cross-strap method: Prior to putting your child in the carrier, unclip the arm straps so they hang loose, and leave the chest clip unbuckled. With your child in the panel, lift the panel up over their back. One side at a time, lift the arm strap into the air above you, then pull firmly straight down your back. The reduces slack in the panel. Then, cross the strap behind your back to the opposite side and buckle the arm strap in. Do the same for the other strap. Don't forget to put the buckle through the safety elastic before buckling. In this method, you don't need to clip the chest clip- you can remove it completely if you'd like!
  6. Use the 2-way adjusters to tighten as needed
  7. Gently move your child's bottom out into the panel, instead of sitting on the waistband. Hold the waistband where the pocket is, and try to keep the pocket straight up and down. Tighten the waistband while holding here. It's easier to tighten if you are lifting your child's weight off of the waistband. Gentle bouncing can also help
  8. Check to make sure the waistband strap is parallel to the floor. Gently adjust waistband, child in panel, and anything else as needed

Back Carry:

For typically developing babies, you can back or hip carry in the LennyLight SSC when your child has sufficient head and trunk control, usually around 4-6months old. Some sides of readiness include being able to tripod sit or when you're naturally placing your child on your hip in daily life.

Method 1:

Crossed arms

-Cross the arm of the shoulder you will bring your child over underneath the other arm. Use your hands to pin the top edge of the panel to your child in the position you want the carrier to be in when baby is up. So, if you want your child arms in, position the top of the panel and hold onto it at the top of your child's shoulder. For arms out, grab your child under the arms with the panel.

-Move your body into your child (as opposed to twisting your child to you). This will allow you to get your child up into the carrier without twisting the fabric.

Once your child is up:

-Hold tightly to the top of the carrier, pinning the straps with your chin or biting with your teeth. This takes practice! 

-Pull the slack down with the bottom of the panel/waistband. Pulling it out can help! Stand up straight and allow gravity to help you. Buckle the waistband, making sure to use the elastic safety band

-Clip the chest clip

-Tighten the webbing as needed

-Gently move your child's bottom out into the panel, instead of sitting on the waistband. Hold the waistband where the pocket is, and try to keep the pocket straight up and down. Tighten the waistband while holding here. It's easier to tighten if you are lifting your child's weight off of the waistband. Gentle bouncing can also help

-Check to make sure the waistband strap is parallel to the floor. Gently adjust waistband, child in panel, and anything else as needed

Method 2:

Hip Scoot

-Buckle the waistband, making sure to use the elastic safety band. Position the panel on your hip on the side you would naturally carry your child. Typically this is slightly more forward on the hip

-Place your child in the panel. Center them in the panel

-When you're satisfied with you child's seat, use the opposite arm from where your child is sitting and put your arm through the arm strap. This is easier if the straps are a little looser prior to starting.

-Using momentum and the strap already on your opposite shoulder, scoot your child behind you. Use your other arm to support your child in the panel as they scoot

-Put your arm through the other strap. Clip the chest clip and adjust your child's position as needed

-Tighten the webbing as needed

-Gently move your child's bottom out into the panel, instead of sitting on the waistband. Hold the waistband where the pocket is, and try to keep the pocket straight up and down. Tighten the waistband while holding here. It's easier to tighten if you are lifting your child's weight off of the waistband. Gentle bouncing can also help

-Check to make sure the waistband strap is parallel to the floor. Gently adjust waistband, child in panel, and anything else as needed

Method 3:

Little Helper

In this method, your child climbs onto your back to help! This method works for older babies.

-Buckle the waistband, putting the buckle through the safety elastic before buckling. Position the panel behind you

-Allow your child to climb onto your back. You can be silly with it! Big kids love to be helpers. Have them hang on at your neck

-Lift the panel up over your child's back, lifting high to remove slack. Let them settle in to the panel

-Put your arms through the straps and clip the chest clip. Adjust your child's position as needed

-Tighten the webbing as needed

-Gently move your child's bottom out into the panel, instead of sitting on the waistband. Hold the waistband where the pocket is, and try to keep the pocket straight up and down. Tighten the waistband while holding here. It's easier to tighten if you are lifting your child's weight off of the waistband. Gentle bouncing can also help

-Check to make sure the waistband strap is parallel to the floor. Gently adjust waistband, child in panel, and anything else as needed

See the videos below for different SSC adjustment examples to help you get the perfect fit!

 

Who we are

Mama & Roo's is a mama-owned and mama-run babywearing brand. We curate high quality, ethically made, vegan baby carriers that help you enjoy every moment with your baby.